Stained glass window film – One technology is that all glass glued pieces of colored film and the joints of the film. On both sides of the glass strip superimposed fine imitate stained glass classic metal profile. First, prepare a sketch of the future colored glass. Stained glass window film necessarily. And laid out the contours of the figure lead tape. Ribbon spread not to touch the sticky fingers of her hand, so she loses its properties. Sequence lines when bonding tape to set so that the cut ends of the tape subsequent closure. When the tape will glue around the circuit. It must roll with a rubber roller and pin clamp assemblies greater fixation.
Glass turns again and already finish contours are cut out from the film details in image. Colored film which tape has an adhesive layer. After removing the protective layer from the details of the picture cut must be carefully. When insert the film and immediately roll it roll between the glass and the film is not form bubbles. Along the contour of the film on top of the stain glass lead tape is lay out again. I draw readers World Councils band on this side of the stained glass window film has to go straight to the joints. And at the same time different from the tape on the back.